On Plati.market you can buy an BEST Upgrade for Flyingbear Ghost 5 3D Printer and it will cost 3$ or 2.52€

Утром меня просили скинуть чертеж на термокамеру  и голову для FBG5. как то так

Highly optimised version to be printed easily and faster in vase mode!
Recommended settings with 0.4 mm nozzle:
CURA: Special Modes -> Spiralize Outer ContourS3D: Layer -> Single outline (Vase Mode)Slic3r: Print setting -> Spiral vase
NO SUPPORT!
50% size ( 30 minute):Layer height: = 0.10 - 0.11 mmLine width/Extrusion Width: 0.55*Speed: 30 mm/sec or slower! (20 mm/sec Wall)Minimum layer time: 3sTemperature: +5CFan: 75%**
100% size (90 minute):Layer height: 0.12 - 0.13 mmLine width/Extrusion Width: 0.65*Speed: 40 mm/sec or slower! (25 mm/sec Wall)Minimum layer time: 6sTemperature: +10 C°Fan: 75%**
200% size (230 minute):Layer height: 0.16 - 0.17 mmLine width/Extrusion Width: 0.8*Speed: 50 mm/sec or slower! (30 mm/sec Wall)Minimum layer time: 10sTemperature: +15 C°Fan: 75%***Yes, it is possible to change the width of the line, up to 0.8 mm even with a nozzle from 0.4 mm**Only for PLA and for better interlayer adhesion, but if the overhang are wrong, increased to 100 as well. (PETG 100%, ABS 0%)
Optimisations: …