Chuck tests the idea that you should you remove Hot-End Screws on ENDER3, CR-10, CR-10 mini to prevent Heat Creep. In the 3D Printing Community, there is a belief that the screws on the sides of the heat block were left in by mistake for shipping but not removed which will cause heat creep in the PTFE tube and cause filament blockage in your 3D printer. This video explores if that is true!

Temperature Meter Used in Video: https://amzn.to/2JpUJOC
Screwdriver set used in Video: https://amzn.to/2PbWocM
Real Sexy Cyborg Channel: https://bit.ly/2hwDqvz

Filament Friday Tool Kit: https://amzn.to/2MOR00X
Filament Friday 3D Printer Starter Kits: https://bit.ly/2EuojUq
Filament Friday Filament: https://amzn.to/2rgz3Ma

Creality Ender 3/CR-10 Parts:
———————————
PTFE Coupling: https://amzn.to/2BJDog1
Capricorn Tubing: https://amzn.to/2nI2ipS
CR10/Ender3 Silicon Heater Block Cover: https://amzn.to/2PaxJ89
CR10/Creality Ender 3 Nozzles: https://amzn.to/2JF3Ii8
Solder Sleeve Kit: https://amzn.to/2Pqqngm
Creality Ender 3 Fan…