Replace the bed springs of the Ender 3 with solid supports which are adjustable to still allow bed levelling, for better heat capability the washers should be PETG or ABS, the rest can be PLA.
MK2 Features a larger Adjuster which can be adjusted with one hand, the new Base locks on to the bed support frame to prevent it turning.
The Locating Washer sits on top of the Adjuster and provides necessary clearance to the underside of the bed, the spigot fits into the adjuster.
Two additional washer thicknesses are provided to cover a range of bed levels if required but the Locating Washer should suit most standard setups.
The standard base is used on three corners, the cable connection corner (rear left) requires the Cable Corner Base, this is compatible with Johnny Whiskey's Ender 3 Cable Chain, if not using a cable chain then use the Cover.https://www.thingiverse.com/thing:2920060
Quantities to print;
MK2 Adjuster - to suit Locating Washer
Base x 3
Cable Corner Base x 1 {this is the only piece that require supports}…

With this Spring aligner for the bed leveling you get more precise leveling and a more stable level and bed. Printed at 20mm/s and resolution 0.1.  You need to print 3 set.
It can be hard to print, so be sure your bed is leveled correct.https://youtu.be/GCx9HVNNzCk

Поддержать меня на patreon: https://www.patreon.com/dmitry_sorkin
Поддержать меня на Яндекс.Деньги: https://money.yandex.ru/to/410017801570057

------------------------

Кронштейн мотора оси Z - https://www.thingiverse.com/thing:3295558
Стабилизаторы пружин - https://www.thingiverse.com/thing:3295578
Хорошая печатная муфта - https://www.thingiverse.com/thing:1329750
Демпферы для моторов - https://www.thingiverse.com/thing:713203

Купить Ender-3: https://letyshops.com/r/aliexpress-3hj7a9lqcyg4cg
Купить Tevo Tornado: https://letyshops.com/r/aliexpress-3hj7a9lqczcw04
Купить Creality CR-10: https://letyshops.com/r/aliexpress-3hj7a9lqczs40k
Купить ролики: https://letyshops.com/r/aliexpress-3hj7a9lqd02s84

Как заставить модель прилипнуть к столу - https://youtu.be/jzbPTVqRoQs
Как правильно откалибровать стол - https://youtu.be/AOyEry7SqMs
Как откалибровать поток - https://youtu.be/VTR_6nGYbu0
Как подобрать параметры печати - https://youtu.be/GInpsJu8bZE
Как исправить проблемы с экструдром - https://youtu.be/5ZxN1LFajrw…