Details on the new SKR Pro Board!

- 15ABlade Fuse added and 30A Fuse changed.
- Built-in 6-channel driver with Dual-Z function Supports 7 ports.
- Changed to a stronger screw terminal.
- USB B...

3/13/2019 Update
I finally got around to adding decorative flourishes to my fountain. I remixed jerry7171's Lions Head Fountain scan and working it over so that I could use it in my Heron's fountain OpenSCAD script. It works pretty well but I have a few tweaks here and there to try. It runs for nearly a minute before trickling out. The corks aren't sealing well and it loses pressure around both corks so the file that's posted has 0.5mm smaller diameter cork holes than what I printed.
This version is printed with 5 perimeters, 25% infill, and no supports. The walls are nearly solid. The infill will spare material between chambers and isn't really structural at all. There is no assembly after printing except for adding two corks and some water.
I will post better pictures of the final fountain when I can get them. Please share makes if you print it! I'm curious if anyone else has success with it and if they have comments/suggestions.
2/13/17 Update
I experimented with the nozzle a little bit over the last two…

This is a fully printable and working Heron's fountain, which is a fountain which isn't requiring a pump or something simmilar. See Wikipedia for a detailed description how it works: https://en.wikipedia.org/wiki/Heron's_fountain
Please note: This is not an easy print as it has to be water tight and even air tight as much as possible! You and your printer have to be able to produce high quality prints or you will end up wasting a lot of time with a non-functional fountain. One single gap will ruin the whole thing!
Short story
When I got my 3D printer, one of the very first things I designed and printed on it was a Heron's fountain. It was not comparable with this one now, it was about the size of one single tank from the current model and due to my not existing knowledge about the fine print things, it would only run for 1-2s with a 2mm "high" fountain.
It was a completely fail.
But I love printing functional things, and some days ago I stumbled about DKoss Heron's Fountain. This remembered me about my initial…