Show me love by sharing your makes! :)
Coolers were designed from scratch in Fusion 360. I took inspiration from my Bullseye on my Ender 3. There are many versions, please read the descriptions below to find one that works for you.
Please Note - The stock cooler works just fine. Only do this change if your stock cooler isn't working well for whatever reason. For example, some have said their stock coolers does not work as well after installing a silicone sock, since it blocks the airflow.
Must print in PETG or ABS. PLA will warp and/or melt close to the bed and nozzle.
Happy to report that all 3 and a half versions fit as designed. There is a make of each version. Be sure to check out the makes if you need help deciding on which version to go with. Thank you everyone for posting your makes! Puts a tear in my eye.
Version 1: I designed so it can be printed in two parts. There's a chamber that's offset to help even out the airflow. I tested this and it works. This version is good if you just want a more direct…