Optimised version to be printed easily and faster in vase mode!
Recommended settings for 0.4 mm nozzle:
CURA: Special Modes -> Spiralize Outer Contour
S3D: Layer -> Single outline (Vase Mode)
Slic3r: Print setting -> Spiral vase
NO SUPPORT!
PS: Keep in mind that the most important factor to have better overhangs is the ratio between line width and layer height, LW / LH >= 5
50% size ( 30 minute):
Layer height: = 0,10-0.11 mm
Line width/Extrusion Width: 0.55* mm (minum)
Speed: 30-40 mm/sec or slower (20 mm/sec Wall)
Minimum layer time: 3s
Temperature: +5C
Fan: 100%*
100% size (90 minute):
Layer height: 0.12 - 0.13 mm
Line width/Extrusion Width: 0.65* mm (minum)
Speed: 40-50 mm/sec or slower (25 mm/sec Wall)
Minimum layer time: 8s
Temperature: +10 C°
Fan: 100%*
200% size (210 minute):
Layer height: 0.15 - 0.16 mm
Line width/Extrusion Width: 0.8 mm *  (minum)
Speed: 50-60 mm/sec or slower (30 mm/sec Wall)
Minimum layer time: 16s
Temperature: +15 C°
Fan: 100%*
Note:
Yes, it is possible to change the width of the…