PLEASE READ THIS TEXT (ALL OF IT !) TO AVOID FAILED PRINTS !!
This is a remix. I like the original mash-up, made by jaydubellu:https://www.thingiverse.com/thing:4199390
But that one is not very suitable for FDM-printing, especially at smaller sizes. Too many thin bits. And the legs break far too easily. Unless you print a very large one. But these things are TINY...
So I fattened it up (making it look even more menacing...), found a good orientation, and added some supports. I also removed the base. It stands well on its own.
This should print well on most FDM-printers, and you should have no problem removing the support material without breaking the legs. I made a supporting tube around the bottom leg, which helps to remove the support without breaking that leg. I also added a model without this support in case you don't need it.
Make sure you set up the right orientation: the supporting tube should be at the bottom. And if you print the one without support, I would advise to set it up so it stands on its left…

TMC2208 UART on BigTreeTech/BIQU SKR V1.1, V1.3, and V1.4 Controllers: So..  You got yourself a BigTreeTech/BIQU SKR v1.1, v1.3, or v1.4 controller board, and you want to use TMC2208 driver modules on it, in UART mode, with Marlin?  It's not difficult to set up.Note: this Instructable is meant for the general-use LPC17…