Once I noticed, that only 5015 blower isn't enough for my minis printed of PET-G and PLA, So I designed a mount for BMG + E3Dv6 direct config, where I can mount two 5015 radial blowers on both sides. For harder to melt materials, like ABS, you may use less RPM for the same result as with high RPM on single 5015. As I am using 3DTouch autoleveling sensor, I made a mount for it too.
As you want to do some edits and change something in my model, I added a source .step source.
Enjoy, post makes and remixes!
List of parts: E3Dv6 hotend; dual drive BMG extruder; NEMA17 slim motor; 4010 or 4020 fan; 2x 5015 radial fan. Also mount is compatible with e3d volcano because of moving 5015 fans and atolevelling sensor in a big range.
The BLTouch offset is 45 ; 16

CR-10 Heavy Duty Modular E3D V6 Mount
I have started a Shapeways shop where you can get these parts printed. I have special versions of the V6 mount designed for Aluminium. At the moment the shop doesn't have much as I'm still setting it up. It's also expensive to get aluminum prints but its an option for those who want it parts that will survive in an enclosure. If no one uses it i will get rid of it. Im just testing the idea outhttps://www.shapeways.com/shops/chito-1
This is a mount for the V6 hot-end by E3D that is stronger and more rigid than some of the mounts that are out there. This mount also comes with an array of possible options for any extra functionality as attachments on the sides.
The minimum you will need to print out is the body and one of the faceplates. There are a variety of wings for different combinations, additions and customizations.
NOTE: Only left side parts are in the library of wings. To print a wing for the right side simply mirror the part in your slicer.
Current modules
5015 fan…