Dear Backers,

With the holiday season approaching, we hope you are all doing well!
These last 4 weeks have been extremely busy for us and we have finally received 30 pre-production Mooltipass Mini BLE prototypes at our office in Switzerland. The Mini BLE looks great:



Here are the main highlights since our last campaign update:

 After using the assembly jig we sent to our device assembler, the latter noticed a high probability of mechanical case damage when the jig isn't properly used. 
 As a result, our device assembler designed and successfully tested an improved assembly jig!





 Also during device assembly, we noticed possible scroll wheel damage when too much torque was applied on a particular screw
 Our device assembler is currently sourcing new screws that will prevent this issue from happening during mass production
 Two weeks ago we sent 10 prototype devices to our FCC/CE testing center to obtain required certifications. Let's cross our fingers!

 On the firmware side of things, we have successfully…

General Motors Co on Tuesday presented a futuristic flying Cadillac - a self-driving vehicle which takes off and lands vertically and carries the passenger above the streets and through the air.