Jožin z bažin club
http://vkontakte.ru/club1522943

Order at: http://www.metalblade.com/cattledecapitation
Cattle Decapitation "Bring Back the Plague" from the "Death Atlas" album.

Cattle Decapitation's Travis Ryan (vocals) comments: "With the cancellation of our ironically titled 'Europandemic Tour' and social distancing recommendations set in place, we found ourselves with not much to do. So we figured why not address the elephant in the room in the form of a music video for 'Bring Back The Plague' and just film it on our mobile phones instead of with an actual crew. Dave didn’t even have access to a drum kit, and nobody is leaving their houses anyway, so we decided to lighten the mood with a video. Everything from the band name to the lyrics to the merchandise to the imagery have always been heavily steeped in metaphors and irony always with tongue firmly in cheek, so this new video by David Hall at Uneasy Sleeper may just be our coup de gras...for better, or for worse. Just don’t take it too seriously, we obviously didn’t. Sit back, have a laugh if you can…

Case for  Ender 3 / 3 Pro / 3 V2 in the "Minimal" style. Included is a file with a case cover with holes for better cooling and reduced fan noise.

This simple hotend fix for your  Creality  Ender 3, CR-10 or just about any  Creality Printer is based on Luke Hatfield design. I created a thicker washer and explain how to install it in this video:https://youtu.be/7tCxO17XZtw
Update 6/22/2020:
I added a 3mm and 2mm thick washer to the files for those that find the 4mm I used in the video is too thick. They print fast so you could print all three and see which works best for your setup.
I printed in PLA as the top of the Hot End should never get hot enough to soften or melt PLA.