set protocols ospf area
0.0.0.0 interface irb.1340 interface-type p2mp
set protocols ospf area
0.0.0.0 interface irb.1340 neighbor
10.20.20.2show ospf interface irb.1340 extensive
Interface State Area DR ID BDR ID Nbrs
irb.1340 PtToPt
0.0.0.0 0.0.0.0 0.0.0.0 1
Type: P2MP, Address:
10.20.20.1, Mask:
255.255.255.0, MTU: 1500, Cost: 10
Adj count: 1
Hello: 10, Dead: 40, ReXmit: 5, Not Stub
Auth type: None
Protection type: None
Topology default (ID 0) -> Cost: 10
show ip ospf interface tenGigabitEthernet 0/0/0.1340
TenGigabitEthernet0/0/0.1340 is up, line protocol is up
Internet Address
10.20.20.2/24, Interface ID 9308, Area 0
Attached via Network Statement
Process ID 10, Router ID
10.20.20.2, Network Type BROADCAST, Cost: 1
Topology-MTID Cost Disabled Shutdown Topology Name
0 1 no no Base
Enabled by interface config, including secondary ip addresses
Transmit Delay is 1 sec, State DROTHER, Priority 1
Designated Router (ID)
10.20.20.1, Interface address
10.20.20.1 Backup Designated router (ID)
10.20.20.1, Interface address
10.20.20.1 Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
oob-resync timeout 40
Hello due in 00:00:01
Supports Link-local Signaling (LLS)
Cisco NSF helper support enabled
IETF NSF helper support enabled
Can be protected by per-prefix Loop-Free FastReroute
Can be used for per-prefix Loop-Free FastReroute repair paths
Not Protected by per-prefix TI-LFA
Index 1/1/1, flood queue length 0
Next 0x0(0)/0x0(0)/0x0(0)
Last flood scan length is 1, maximum is 40
Last flood scan time is 0 msec, maximum is 1 msec
Neighbor Count is 1, Adjacent neighbor count is 1
Adjacent with neighbor
10.20.20.1 (Designated Router)
Suppress hello for 0 neighbor(s)
router ospf 10
router-id
10.20.20.2 no log-adjacency-changes
area 0 authentication
redistribute connected subnets route-map ospf_not_nat
redistribute static subnets route-map ospf_not_nat
network
10.20.20.0 0.0.0.255 area 0
distribute-list 6 in